GainBrainSign up

Estimated one-rep max: the six formulas and when they disagree

GainBrain estimates a one-rep max from any set with the Epley formula by default, counting the reps you had left in reserve from your RPE. It also offers the Brzycki, Lombardi, Wathen, Mayhew and O'Conner formulas, names the formula behind every figure, and flags estimates from sets above 10 reps as rough.

Updated

The six formulas

Each formula turns a weight w lifted for r reps into an estimate of the most you could lift once. All of them were fitted on low-rep sets.

Epley
w × (1 + r / 30)The most common, and GainBrain's default. Reads high at higher reps.
Brzycki
w × 36 / (37 − r)Reads lower than Epley past about 8 reps and breaks down at very high reps.
Lombardi
w × r^0.10The flattest curve at high reps.
Wathen
100 × w / (48.8 + 53.8 × e^(−0.075 r))Sits between Epley and Brzycki across most of the useful range.
Mayhew
100 × w / (52.2 + 41.9 × e^(−0.055 r))Fitted on bench press data, so it suits upper-body pressing.
O'Conner
w × (1 + 0.025 r)The most conservative.

How far apart they are

On the same set the formulas disagree. For 225 lb lifted 5 times they spread over about 6%, and for 10 reps about 8%. None of them is the correct one, which is why GainBrain never shows an estimate without its formula.

Estimated one-rep max, in lb, from a set of 225 lb
Formula5 reps10 reps
Epley263300
Brzycki253300
Lombardi264283
Wathen262303
Mayhew268295
O'Conner253281

Reps in reserve

Five reps at RPE 8 is not the same effort as five reps to failure: an RPE of 8 means about two reps were left. By default GainBrain adds those reps before estimating, reading reps in reserve as 10 minus the RPE, so 5 reps at RPE 8 is estimated as a 7-rep effort.

A set with no RPE is estimated from the reps you did, as though it ended at failure. That is the low end of the range, so skipping the RPE never makes an estimate bigger. Through Claude you can ask for the plain reps basis instead, which treats every set as a set to failure.

Why sets above 10 reps are flagged

Past 10 effective reps every formula is extrapolating, and they disagree by more than strength changes in a month. GainBrain still shows the estimate, marked as rough, so a 20-rep set or an easy set with five reps left cannot quietly set a headline record.

Why one formula for every lift

Picking a different formula for each lift, say Mayhew for presses and another for squats, can be argued for one lift at a time. It breaks every comparison between lifts, because two numbers from two equations cannot be compared. So the app uses one formula throughout, Epley unless you ask Claude for another, and says which.

Estimated one-rep maxes for bodyweight movements are calculated because the arithmetic applies, but a one-rep max push-up is not a meaningful number.

Try it with your next workout