GainBrainSign up

How GainBrain counts training volume

GainBrain counts training volume in working sets per muscle per week. Warmups never count, a set counts once for its main muscle and 0.5 for each muscle it trains indirectly, and muscle balance is read over the last 14 days averaged per week so a split routine never makes a muscle look untrained.

Updated

Working sets and hard sets

A working set is any set that is not a warmup. Muscle balance and the body map count working sets, so they still work if you never rate a set's effort.

A hard set is a working set rated RPE 7 or higher. The weekly summary counts hard sets, to show how demanding a week was. A set with no RPE is never counted as hard, so patchy rating understates your effort rather than inventing it.

The two figures answer different questions and will not match. Working sets ask whether a muscle is being trained at all; hard sets ask how hard the training was.

Warmups never count

Warmup sets are recorded, because they cannot be reconstructed later, but they are left out of every volume number. Three warmup squats and three working squats are three sets, not six.

Direct and indirect sets

Every exercise has one primary muscle and may have secondary ones. A set counts 1 toward its primary muscle and 0.5 toward each secondary, so a pressing day shows up for the triceps instead of leaving them looking neglected. Half a set is a common convention, not a measurement, and GainBrain says so wherever the number appears.

Each muscle counts once per set, at the larger amount. A lift that lists both chest and upper chest, like a pike push-up, adds half a chest set, not a whole one.

Volume is reported for 17 muscles, from chest, lats and quads to rear delts, adductors and forearms.

Why the window is 14 days

Muscle balance, the body map and the push-to-pull ratio are read over the last 14 days and divided by two, so the figure is still sets per week. A rolling seven days on a push, pull and legs split would drop the push day the moment it turned eight days old and call the chest untrained; two weeks always contain a whole split.

Weekly series, such as hard sets per calendar week, still use single weeks. Weeks follow each session's own time zone, so a 9 pm session stays on the day you trained.

Targets

With no plan of your own, each muscle is compared with 10 to 20 working sets a week. That range is a widely repeated rule of thumb, not a measured optimum, and it is there so the question "am I doing enough?" has a stated reference.

You can replace it with your own plan, a range per muscle with a reason for each, by asking Claude to set your training targets. Going above a range is not flagged; only a limit you set yourself warns.

Tonnage

Tonnage is weight times reps over working sets. Three rules keep it honest:

  • One-arm and one-leg lifts are logged per side and counted for both, so a 50 lb dumbbell row is 100 lb a rep. Otherwise unilateral work would read as half as hard as it is.
  • Bodyweight lifts count total system weight: your bodyweight plus anything added. Fifteen push-ups at 200 lb is 3,000 lb, more than most barbell sets, so tonnage is reported separately for each type of equipment rather than blended.
  • Assisted lifts are logged as the assistance the machine shows and counted as your bodyweight minus it. Without a bodyweight from the last 30 days, the set has no load rather than a guessed one.

Nothing is stored pre-calculated

Every figure is worked out from your logged sets whenever you look. Weights are stored in kilograms and converted for display, so switching between pounds and kilograms never changes your history, and a change to a rule never leaves old numbers behind.

Try it with your next workout